Q436 |
 |
 |
 |
 |
 |
| TECHNICAL SPECIFICATION (Q436) |
|||
| Potentiometer Input | |||
| Resistance (End to End): | 100W up to 100KW | ||
| Input Impedance: | >1MW | ||
| Input Excitation: | 500mV, 5mA maximum drive. | ||
| Zero Turn-Up: | 80% of full scale input | ||
| Span Turn-Down: | Down: 80% of full scale input (Table 1) | ||
| Common Mode Rejection: | 1800VDC (input to power) | ||
| Output | Voltage Output | ||
| Output: | 0-5V, 0-10V | ||
| Source Impedance: | <10W | ||
| Drive: | 10mA, max. (1KW min. @ 10V) | ||
| Current Output | Output: 0-1mA, 0-20mA, 4-20mA | ||
| Source Impedance: | >100KW | ||
| Compliance: | 0-1mA; 7.5V, max. (7.5KW, max.) 0-20mA; 12V, max. (600W, max.) 4-20mA; 12V, max. (600W, max.) | ||
| Accuracy (Including Linearity, Hysteresis) | |||
| ±0.1% maximum at 25°C. | |||
| Stability | Temperature: | <±0.05%/°C maximum of full scale range. | |
| Response Time (10 to 90%) | <200mSec., typical. | ||
| CMRR | 120dB @ DC, >100dB @ 60Hz | ||
| Isolation | 800VDC between line power and input, output | ||
| EMC Compliance (CE Mark) | |||
| Emissions: | EN50081-1 | ||
| Immunity: | EN50082-2 | ||
| Safety: | EN50178 | ||
| LED Indication (green) | Active DC power | ||
| Humidity (Non-Condensing) | |||
| Operating: | 15 to 95% (@ 45°C) | ||
| Soak: | 90% for 24 hours (@ 65°C) | ||
| Temp Range | Operating: | 0 to 55°C (32 to 131°F) | |
| Storage: | -25 to 70°C (-13 to 158°F) | ||
| Power | Consumption: | 1.5W typical, 2.5W max | |
| Range: | 100 to 240VAC, ±10%, 50 to 400Hz | ||
| Weight | 0.48 lbs | ||
| Agency Approvals | Model Q436 is designed to meet or exceed UL and CSA requirements. Certification and approval pending. CE Compliance per EMC directive 89/336/EEC and Low Voltage 73/23/EEC. | ||
|
Application The Q436's high density DIN rail mounting offers an extremely compact solution for saving valuable panel space. Configuration For example, in a valve positioning application a potentiometer is sometimes used as a feedback signal. Quite often a wide open valve is only a 25% turn of the feedback potentiometer. In this case the Q438 can easily be adjusted with the zero and span to provide a full scale output signal (e.g. 4-20mA) representing 0-25% or even 50-75% of the potentiometer input. Unless otherwise specified, the factory presets the Model Q436 as follows:
|
The Q436 is AC powered and will accept any power between 85 and 265VAC. For other output ranges, refer to Tables 1 and 2 to reconfigure switches SW1 and SW2 for the desired input and output ranges.
|
